Author Topic: Water to Sequencer?  (Read 2947 times)

Toupie

  • Jr. Member
  • **
  • Posts: 62
    • View Profile
Water to Sequencer?
« on: October 16, 2013, 09:50:00 pm »
How do I feed a sequencer with water?
Other then manually putting it in the Input area of the sequencer that is.


Qon

  • Full Member
  • ***
  • Posts: 112
    • View Profile
Re: Water to Sequencer?
« Reply #1 on: October 16, 2013, 09:53:14 pm »
Just like any other material :Q
Do you have water in the "recipe"?
I have no problem with this. Maybe it's a bug?
It doesn't pick up more water than it's recipe qontains.
« Last Edit: October 16, 2013, 09:58:11 pm by Qon »

Qon

  • Full Member
  • ***
  • Posts: 112
    • View Profile
Re: Water to Sequencer?
« Reply #2 on: October 17, 2013, 12:28:39 am »
Maybe you are trying to pick up the water with the output?

Toupie

  • Jr. Member
  • **
  • Posts: 62
    • View Profile
Re: Water to Sequencer?
« Reply #3 on: October 17, 2013, 12:53:39 am »
It seems it is my water that is acting up. If I put an Materializer so it outputs water from a compressor in direction 0, 1 or 4 the water will not fall or act as water, but if I rotate it so it outputs the water in directions 2, 3 or 5 it all works as expected.

So it wasn't the Sequencer that was the fault, it was the water.

Qon

  • Full Member
  • ***
  • Posts: 112
    • View Profile
Re: Water to Sequencer?
« Reply #4 on: October 17, 2013, 01:29:52 am »
At times like these we need allies we qan trust! We qan't have our water betraying us! I sentence thee, water, to death by Fire!  :>